This simple logic group cyclically requests the status query from the Robonect module for Husqvarna (Automower) or Garden robotic lawnmowers.
The current status is queried every 10 minutes via a "cyclic transmitter" by http request.
The JSON response of the http query is evaluated via a text processor and sent to the KNX bus via the outputs.
The following information is requested:
- Operating mode
- State of charge
- Operating hours
- Timer status
- Knife condition
- Knife operating hours
- Error state
- next start and
- WLAN signal strength
For better comprehensibility, the values for "Status", "Operating mode" and "Timer status" are each translated into meaningful information (in text form) using a separate translator tool.
The following are the possible issues:
Value 0 = Status is determined
Value 1 = Automower parks
Value 2 = Automower mows
Value 3 = Automower searches for the charging station
Value 4 = Automower charging
Value 5 = Automower searching (waiting to be moved in manual mode)
Value 7 = Error status
Value 8 = loop signal lost
Value 16 = Automower switched off
Value 17 = Automower is sleeping
Value 0 = Auto
Value 1 = Manual
Value 2 = Home
Value 3 = Demo
Value 0 = Disabled
Value 1 = Active
Value 2 = Standby
In order to use the logic group, the IP address (replace ) of the module and, if necessary, the user name and password must be entered in the http request element "http query".
Further information on the interface is available at https://robomaeher.de or https://forum.robonect.de/viewforum.php?f=10.