HUE control

With this logic group, Philips HUE luminaires can be controlled via the EIBPORT (via HUE Bridge).
Via http request command, it is possible to switch the luminaires on and off or call up colours via KNX telegram.

Colours are set via 3 KNX group addresses (red, green and blue).
Important: The colour is only sent to the Philips HUE Bridge via http request when the http request element is triggered via the "Trigger" input!
Tip: The EIBPORT's "colour picker" visualisation element has an extra field for this purpose. The group address of the trigger entered here is only triggered after a colour has been set.
The "Calculator" tools in this branch are necessary to factor and adjust the converted HSB values from the "Data Converter" element for the HUE luminaires. Since only integers are allowed for the values of colour saturation and brightness, they are rounded afterwards for this reason.

The HUE luminaire is switched on and off with this logic group via the "Switch" input. Permitted values for this input are "0" (switch off) and "1" (switch on).
Here, too, it is necessary to trigger the http request. The distributor was used for this purpose. First the value (on or off) is set and then triggered via the trigger.

Note: Depending on the HUE model and type, the complete colour range (especially the shades green and blue) cannot be reproduced.

The following information, which is in the http request, must be replaced:
- IP address of the Philips HUE Bridge
and - The API token is generated with the Philips HUE Bridge.

HUE control

2K
This logic group is compatible with: EP, LOM
*With the download you accept the Notes on use for logic groups.